*Includes new environmental lighting and weather systems (clouds, rain, snow, thunderstorms, and fog). Includes working hump at Barstow with retarder brake squeal sounds. Includes Tehachapi Pass and the Palmdale cutoff betwen Mojave and Hiland *Version 3 is compatiable with version 1 and version 2 content! GPU: Intel HD4400 graphics chip, or GeForce x40 card with no less than 1 gig of Video Ram. 1.7 GB of hard driveĪre the minimum computer specs that we recommend: THE HIGH TOWER AT BARSTOW YARD IN CALIFORNIAħ or newer 64 bit operating systems. Includes UP-BNSF Mojave Subs, Barstow-Yermo, and the BNSF Needles Sub! If you don't see/hear the AWS test, then you will know that the train won't drive properly.IMPORTANT NOTE: All of our trainsets and route addons are compatiable with v3. If you switch cabs, however, you must repeat all of the above steps. After a station stop, however, you must remember to increase the throttle and THEN release the brakes. Once you've started moving the first time, stopping and starting are pretty much the same as in other DMU's.

Release the brakes completely by pressing as necessary, or use the mouse to move the lever to 0%. Increase the throttle to 200% - 400% by pressing A as necessary, or use the mouse to move the throttle.Ĩ. If it is on, press Y to turn it off, or click on the red light.ħ. Make sure DRA is off (the red DRA light should be dark). Set the exterior lights as desired - the headlights, tail lights, and marker lights are all controlled by separate switches, or use the H, J, and K keys.Ħ. Press W twice to move it to forward again, or use the mouse to move it.ĥ. The reverser will have been set to Reverse (-100%) during the AWS test. Cancel the alert by pressing Q, or by clicking on the AWS reset button.Ĥ. The AWS self-test will cause the AWS horn to sound and the reset button to illuminate. moving the reverser lever itself won't do anything.ģ. Note: You MUST use the W key for this step. Press W once to move the reverser from Off to Forward.

If it isn't, press Z to start the engine.Ģ.

Starting with the reverse in neutral, the throttle at 0%, and the brakes fully applied.ġ. In the Standard Scenario list, you should find Class 156 Driving Tutorial that uses the TestTrak route. Under Drive by Train, find Class 156 ScotRail 2000. There is, however, a tutorial that will take you through these steps. Despite what some people say, there is nothing about the procedure in the Class156_Manual.pdf file. Since this question has already appeared, and is likely to appear again, here's a checklist. I don't know if this helps - I dl this in 2012 and it pertains to the OOvee version only:

Run 8 train simulator reskin downloads